This station also has the advantage of not being an end point. The animation does take some time to occur, whether that time is a big deal is up to you. This station has the advantage that trains do not need to turn around. You can play with signal placement based on train length if needed. Signals on the exit prevent them leaving until the first interchange is cleared. Our first RORO station! Similar to our previous station, signals turn the station into a block, and the two interchanges on the entrance and exit into blocks. The way the rails themselves matter little compared to proper signalling) (Another example, notice how the rail connections to the station are different. As in, you are not intending on trains traveling through this station or around to another area. This station is useful as an end of the line station. Signals on exiting prevent entry into the intersection, again the RED block, until a train has entered the light green exit rail. Signal placement here prevents trains on our lower rail, the light blue, from entering unless the intersection ITSELF(Red) is clear as well as atleast one lane on the station. This is a, as im going to start calling it, a Roll In Roll Back station. How you design your overall network is going to dictate in what way you connect your stations. There isnt a wrong way so long as trains are able to move in and out freely. Keep in mind: There are several ways to do a train station. READ: Voxel Tycoon Basic Guide For New Players Too long of a train going into an intersection it may block the intersection even if the engine is in the exit.-This guide is going to be built overtime! I will add to, remove, or expand upon concepts as time continues. – SEPARATE your rails into blocks! This is actually what signals are doing and you need to block your rails out in accordance to the lengths of your trains. Made an intersection, then an exit right after and having trains stop in the intersection? Expand your signals to include this exit in the Pre-signal/signal network. 1 Setting up your first train route 1.1 Locating your route 1.2 Building train stations 1.3 Connecting train stations 1.4 Building a depot 1.5 Adding a train 1. Pre-signal INTO the intersection regular Signal OUT They will hold a train short of the intersection, if that is planned, until a route into and out of the intersection is open Your Pre-signals are how you route your trains. One presignal before two signals with one occupied? Yellow light. One presignal before one signal that is occupied? Red light. Pre-Signals are RELAYS! They display the same signal as the signals in front. For starters, welcome! Hopefully you have a need for a different intersection or otherwise and this will provide! Some basic things to keep in mind:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |